Hi All,

I have attempted to run fsk_modem_app with some adjustments to the setup through reading various OpenCPI documentation.

fsk_modem_app.xml runs without errors but the received loopback signal image file isn't readable by using the eog fsk_dig_radio_ctrlr_fmcomms_2_3_txrx.bin command.

The FSK_App_Getting_Started_Guide_E31x document on the final page has an example image of a spectrum analyzer with the bandwidth of the signal being about 500 MHz. My signal bandwidth is about 200 MHz and falls off a lot sharper than the example signal. This points to the transmitted signal being an issue.

From experience with Ettus SDRs the hardware hasn't been defective so it's assumed the software is the issue.

Network mode is the used mode as it is used in guides and forum posts more often. Listed content is not necessarily in order of 'discovery'.

The general format of the information below is as follows:

<Location of presented information (title/section, forum post etc.)>

<Information from the section/forum post/etc.>

<My comments about the information>